LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 85 (15 Engine - Cylinder Head, Valve Drive 4.0L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 155519 Removing And Installing Solenoid Hydraulic Valve For Valve Lift Adjustment (V8 BITURBO) >> Installing Solenoid Hydraulic Valve For Valve Lift Adjustment

Installing Solenoid Hydraulic Valve For Valve Lift Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:

    Replace O-ring on solenoid hydraulic valve for valve lift adjustment.

    Tighten fastening screws for solenoid hydraulic valve for valve lift adjustment to > Tightening torque 5 Nm (3.5 ftlb.)  .

    Tighten fastening nuts for engine wire harness guide to > Tightening torque 9 Nm (6.5 ftlb.) (6.6 ftlb.)  .

scientia non olet · About LEMON Manuals