Installing Coolant Temperature Sensor
WARNING: This page is about a different variant/trim than selected.
Information
- O-rings must always be replaced.
- O-rings must be coated lightly with Kluber Syntheso Glep.
- Installation is performed in reverse order.
- Replace O-rings and grease with Kluber Syntheso Glep.
- Screw in and tighten screw on coolant temperature sensor.
> Tightening torque 9 Nm (6.5 ftlb.)
- Tighten screw on screw-type clamp securing pressure hose for charge-air cooler to pressure pipe > Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.3 ftlb.)