LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 74 (19 - Engine - Cooling 4.0L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 192019 Removing And Installing Cooling Fan Housing (Radiator Frame) >> Installing Cooling Fan Housing (Radiator Frame)

Installing Cooling Fan Housing (Radiator Frame)

WARNING: This page is about a different variant/trim than selected.

Information 

The air guide can fall down when removing the cooling fan housing (radiator frame).

Roughly position the air guide in the vehicle during installation and reposition it when guiding in the cooling fan housing (radiator frame).

Information 

Make sure that the cooling fan housing (radiator frame) is seated correctly in the upper guides.

  1. Installation is performed in reverse order. Pay particular attention to the following:

    Screw in and tighten screws for cooling fan housing (radiator frame) > Tightening torque 5 Nm (3.5 ftlb.) 

scientia non olet · About LEMON Manuals