Installing Charging Socket
- Electric shock
- Short circuit
- Fire
- Explosion
→ Only appropriately trained and authorized persons may work on high-voltage vehicles and components
→ Required qualification, high voltage technician or high voltage expert.
→ Observe national requirements and legislation for this work.
→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.
→ Observe general warning notices for working on the high-voltage system.
→ > 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM
Information
Check that the high-voltage connectors are engaged fully by carrying out a visual inspection and by pulling gently on the high-voltage connectors.
Information
Make sure that the water drain is not kinked.
- Installation is performed in reverse order. Pay particular attention to the following:
Screw in and tighten fastening screw securing ground line to body > Tightening torque 8 Nm (6 ftlb.)
Screw in and tighten fastening screws securing charging socket to body > Tightening torque 5.6 Nm (4 ftlb.) + 0.6 Nm (0.3 ftlb.) - 0.8 Nm (0.4 ftlb.)