Checking Fuel Pressure
WARNING: This page is about a different variant/trim than selected.
- > 9900 - PIWIS tester 3 must be connected and switched on.
- Switch on ignition (fuel pump is activated briefly).
- Perform fuel pressure test using > 9900 - PIWIS Tester 3
.
- 3.1 Select the Diagnostics function.
- 3.2 Select the DME control unit in the control unit overview.
- 3.3 Switch to the Drive links/checks menu item.
- 3.4 Select the Drain fuel tank function and press F12 = Next.
- 3.5 Activate the Drain fuel tank (= activate fuel pump) function by pressing F8 = Start. The process can be ended at any time by pressing F8 = Stop.
- 3.6 Read off the pressure shown on the pressure gauge.
Check fuel pressure:
> Fuel pressure 6.5 bar +/- 0.2 bar
- 3.7 Deactivate the Drain fuel tank
function by pressing F8 = Stop.
- 3.7.1 Exit the function.
- 3.8 Switch off ignition, switch off > 9900 - PIWIS Tester 3 and disconnect adapter line in the vehicle.
- 3.9 Perform holding pressure test.
- 3.9.1 System pressure must only drop by max. 1 bar after 30 minutes.
> Pressure 5.5 bar +/- 0.2 bar
- 3.9.1 System pressure must only drop by max. 1 bar after 30 minutes.