Installing Camshaft Controller Actuator

WARNING: This page is about a different variant/trim than selected.

NOTE: Dirt and contamination

Risk of damage to units or components
→ Protect components from dirt and contamination.

→ Clean or replace dirty components.

Installation is performed in reverse order. Pay particular attention to the following:
Replace sealing ring on camshaft controller actuator.

Screw for camshaft controller actuator > Tightening torque 9 Nm (6.5 ftlb.)

Nut for coolant pipe holder, top: > Tightening torque 9 Nm (6.6 ftlb.)

Screw for coolant pipe holder, bottom: > Tightening torque 8 Nm (6 ftlb.)