LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (37 Automatic Transmission - Actuator, Housing 2.9L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 373455 Replacing Double-Clutch Transmission >> Subsequent Work >> Notes

Subsequent Work: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Install double clutch transmission.

    > 373419 REMOVING AND INSTALLING DOUBLE CLUTCH TRANSMISSION (V6 BITURBO) 

    > WM, 373427 REMOVING AND MOUNTING DOUBLE CLUTCH TRANSMISSION (V6) 

  2. Maintenance of vehicle data (Only for model year 2017) 
    1. 2.1 Connect PIWIS Tester and switch on ignition.
    2. 2.2 Start the diagnostic application.
    3. 2.3 Select Additional menu by pressing F7.
    4. 2.4 Select the Maintenance of vehicle data  function. Press F12 until PR numbers appears in the Value group column.
    5. 2.5 SP7 - Repair data record for main transmission  must be selected. Press F12 to continue.
    6. 2.6 Save the values by pressing F8. Wait until the message Modified values have been buffered  appears.
    7. 2.7 Press F12 to switch to Log management. Open the log by pressing F10 and check that vehicle equipment SP7 - Repair data record for main transmission  is displayed.
  3. Program the transmission.
    1. 3.1 In the overview, select the required PDK control unit.
    2. 3.2 Coding/programming  must be selected.
    3. 3.3 Automatic programming  must now be selected. (The DME and transmission control units are then programmed and coded.)
    4. 3.4 Switch ignition off and then on again.
    5. 3.5 In the overview, select the required PDK control unit.
    6. 3.6 Select the Maintenance/repairs  menu.
    7. 3.7 Select Calibration.  (Read the warnings and test prerequisites displayed on the Tester.)
    8. 3.8 Set the engine and transmission to the specified nominal values shown on the PIWIS Tester.
    9. 3.9 Perform calibration.
  4. Perform a test drive.