Topping Up ATF
WARNING: This page is about a different variant/trim than selected.
- Fill in ATF.
- 1.1 Screw > VAS 6262/2 - adapter for filling ATF oil hand-tight into the lifting tube -2- .
- 1.2 Connect > VAS 6262A - adapter for oil filling .
- 1.3 Shake ATF container (1 liter) well and screw it onto > VAS 6262A - adapter for oil filling .
- 1.4 Fill in ATF until you see a constant discharge of oil at -3- .
- 1.5 Screw in and tighten oil inspection plug -3-
.
> Tightening torque 10 Nm (7.5 ftlb.)
Overview of oil filler screw and drain plug
- Install front underbody cover.
> WM, 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY
- Lower the vehicle.