Disassembling Spring Damper
WARNING: This page is about a different variant/trim than selected.
- Remove the -1-
shock absorber mounting.
- 1.1 Unscrew -2- nut using >T10001 - the shock absorber set while at the same time holding back the multipletooth screw of the piston rod -3- .
- 1.2 Remove shock absorber mount -1- from piston rod -3- .
Shock absorber mounting
- Pull supporting washer -1-
from piston rod -2-
.
Support washer
- Remove stop buffer -1- and protective sleeve -2- .