LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Panamera 4 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 95 (43 Leveling System, Air Suspension, Damper Control 4.0L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 436637 Disassembling And Assembling Rear Spring Damper >> Disassembling And Assembling Spring Damper >> Assembling Spring Damper

Assembling Spring Damper

WARNING: This page is about a different variant/trim than selected.
  1. Fit stop buffer -1-  and protective sleeve -2-  .
    1. 1.1 Fit protective sleeve -2-  on stop buffer -1-  .
    2. 1.2 Slide stop -1-  buffer with protective sleeve -2-  onto piston rod.
      G15860955Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Stop buffer and protective sleeve

  2. Slide supporting washer -1-  onto piston rod -2-  and check that the cut-out in the supporting washer is positioned correctly in relation to the piston rod.
    G15860956Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Support washer

  3. Fit shock absorber mounting -1-  .
    1. 3.1 Slide the shock absorber mounting -1-  onto the piston rod -3-  as far as the support washer stop.
    2. 3.2 Screw on the nut -2-  and tighten using >T10001 - shock absorber set  while at the same time holding back the multiple-tooth screw of the piston rod -3-  .

      > Tightening torque 53 Nm (39.1 ftlb.) 

      G15860957Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Shock absorber mounting

scientia non olet · About LEMON Manuals