Removing Roof Trim Panel
WARNING: This page is about a different variant/trim than selected.
- Fold backrests forward.
- Move front seats all the way forward and tilt them to the rear.
- Unscrew screws -1-
at the front.
Front screws
- Only for vehicles with electric glass slide/tilt roof (I-no. 3FE)
Release and disconnect electric plug connections on sliding roof control unit.
> 606519 REMOVING AND INSTALLING CONTROL UNIT FOR SLIDING ROOF
Information
The help of another person is required.
- Only for vehicles with electric glass slide/tilt roof (I-no. 3FE)
Unclip headliner -2- in the sliding roof cut-out area.
Headliner
- Unclip rear roof trim panel -2-
and loosen Velcro fasteners.
Rear roof trim panel
- Unclip roof trim panel -2-
at the front.
Front roof trim panel
- Unclip electric wire harness -1- (-arrows- ).
- Release and remove electric line for reading light.
Electric wire harness
Information
Make sure that the roof trim panel does not buckle.
- Remove roof trim panel by pulling it forward.