LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Panamera 4 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 49 (70 Linings, Insulation - Wagon -- 971 - PANAMERA (971)) >> WM, 705719 Removing And Installing A-Pillar Trim Panel >> Installing A-Pillar Trim Panel

Installing A-Pillar Trim Panel

WARNING: This page is about a different variant/trim than selected.

Information 

Check fixing clips, retaining clips and expanding clips for damage and replace them if necessary.

Check that all fixing clips, retaining clips and expanding clips are fitted at the correct position.

  1. Move retaining clip -1-  on A-pillar trim panel -2-  as far as it will go -arrow-  .
    G15874323Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Retaining clip on A-pillar trim panel

  2. Clip rebound strap -1-  into mounting point on A-pillar trim panel.
    G15874324Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Rebound strap on A-pillar trim panel

  3. Fit and clip in A-pillar trim panel -1-  in the cut-out using retaining clip -2-  and fixing clips -3-  .
    G15874325Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    A-pillar trim panel