Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Screws securing transfer gear to double clutch transmission | M10 x 70/replace | Initial tightening | 50 Nm (37 ftlb.) | ||
| Screws securing transfer gear to double clutch transmission | Final tightening | + 90° | |||
| Screws securing transfer gear to double clutch transmission | M10 x 75/replace | Initial tightening | 40 Nm (30 ftlb.) |