Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Screws securing cardan shaft bearing to body | M8 x 25 | Tightening torque | 20 Nm (15 ftlb.) | ||
| Screws securing cardan shaft to rear axle differential/M10 | Step 1 | Initial tightening | 18 Nm | ||
| Screw securing cardan shaft to rear axle differential/M10 | Step 2 | Initial tightening | 50 Nm | ||
| Screws securing cardan shaft to rear axle differential/M10 | Final tightening | Final tightening | + 120° | ||
| Screws on front tunnel support | M10 x 25 | Initial tightening | 60 Nm (44 ftlb.) | ||
| Screws on front tunnel support | M10 x 25 | Final tightening | + 45° | ||
| Screws on rear tunnel cross member | M10 x 30 | Tightening torque | 55 Nm (41 ftlb.) | ||
| Screws securing heat shield to tank holder | Tightening torque | 15 Nm (11 ftlb.) | |||
| Nut securing heat shield to body | Tightening torque | 2 Nm (1.5 ftlb.) |