Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Air inlet housing cover to body | Hexagon nut | Tightening torque | 3.5 Nm (2.5 ftlb.) | ||
| Mounting saddle to spring strut (PASM only) | M8 thread | Tightening torque | 30 Nm (22 ftlb.) | ||
| Mounting saddle to body | M10 x 35 thread/observe specified tightening sequence/always use new screws or bolts following removal | Initial tightening | 40 Nm (30 ftlb.) | ||
| Mounting saddle to body | M10 x 35 thread/observe specified tightening sequence/always use new screws or bolts following removal | Final tightening | + 90° | ||
| Air line to air-spring strut | Tightening torque | 3 Nm (2 ftlb.) |