LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (43 Leveling System, Air Suspension, Damper Control 2.0L -- 95B - MACAN (95B)) >> WM, 430117 Bleeding And Filling The Levelling System >> Bleeding And Filling The Levelling System >> Releasing Air From One Air Spring

Releasing Air From One Air Spring

WARNING: This page is about a different variant/trim than selected.

Information 

This function is used for bleeding when working on an air spring or the lines of an air spring (without any loss of system air).

The air from up to two air-spring struts can be stored in the pressure accumulator.

  1. Connect the PIWIS Tester  to the vehicle and start it. Switch on ignition.
  2. Start the diagnostic software.
  3. Select Level control/PASM  control unit.
  4. Select Maintenance/repairs  .
  5. Press F12 to select Replacement of an air spring  .
  6. Then, select Bleeding an air spring from the pressure accumulator  .
  7. Follow the instructions on the Tester.
scientia non olet · About LEMON Manuals