Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | De... | Type | Basic v... | Toleran... | Toleran... |
|---|---|---|---|---|---|
| Bottom screw securing rear final drive to rear axle carrier | M10 x 92/replace | Initial tightening | 40 Nm (30 ftlb.) | ||
| Bottom screw securing rear final drive to rear axle carrier | Final tightening Initial | + 90° | |||
| Rear axle housing, front to body | M14 x 1.5 x 135 thread/always replace screws following removal | tightening | 115 Nm | ||
| Rear axle housing, front to body | M14 x 1.5 x 135 thread/always replace screws following removal | Final tightening | + 90° |