Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Fastening screw for engine suspension eyelet | Initial tightening | 8 Nm (6 ftlb.) | |||
| Fastening screw for engine suspension eyelet | Final tightening | + 90° | |||
| Adapter for fuel supply line/high-pressure pump | Replace/coat thread with clean engine oil | Tightening torque | 40 Nm (30 ftlb.) | ||
| Fuel line adapter | Replace | Tightening torque | 40 Nm (30 ftlb.) | ||
| Union nut for fuel line | Coat ball on fuel supply line with engine oil | Tightening torque | 20 Nm (15 ftlb.) | ||
| Fastening screw for fuel line | Tightening torque | 5 Nm (3.5 ftlb.) | |||
| Heat shield on fuel pump | M6 x 16 | Tightening torque | 8 Nm (6 ftlb.) |