Installing Throttle Housing

WARNING: This page is about a different variant/trim than selected.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Clean the sealing face.
2. 1.2 Replace sealing ring.
3. 1.3 Tighten screws for throttle valve.
  - Tightening torque 7 Nm (5 ftlb.)
4. 1.4 Connect and lock electric plug connection.
5. 1.5 Tighten screw-type clamp.
  - Tightening torque 5.5 Nm (4 ftlb.)