Installing Fuel Pressure Sensor (High-Pressure)

WARNING: This page is about a different variant/trim than selected.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Replace sealing ring on the fuel pressure sensor.
2. 1.2 Coat the thread on the fuel pressure sensor with Microgleit DF 977S. Observe a drying time of at least 5 minutes before fitting.
3. 1.3 Tighten fuel pressure sensor.
  - Tightening torque 27 Nm (20 ftlb.)
4. 1.4 Tighten nut on intake-ar distributor support.
  - Tightening torque 10 Nm (7.5 ftlb.)
5. 1.5 Tighten screw on intake-air distributor support.
  - Tightening torque 20 Nm (15 ftlb.)