Preliminary Work

WARNING: This page is about a different variant/trim than selected.

Remove cover for front underbody.
- WM, 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY
Remove engine cover (design cover).
- WM, 108319 REMOVING AND INSTALLING ENGINE COVER (DESIGN COVER) (V6 TURBO)
Remove front strut.
- WM, 408619 REMOVE AND INSTALL FRONT STRUT
Remove cross panel.
- WM, 508119 REMOVING AND INSTALLING CROSS PANEL (DISASSEMBLING PLENUM PANEL)
Remove heat shield.
- WM, 261219 - REMOVING AND INSTALLING HEAT SHIELD (V6 TURBO)
Loosen oxygen sensor downstream of catalytic converter.
- WM, 247319 REMOVING AND INSTALLING OXYGEN SENSOR DOWNSTREAM OF CATALYTIC CONVERTER (V6 MONOTURBO)
Remove camshaft controller actuator on bank 1 and bank 2.
- WM, 153919 - REMOVING AND INSTALLING CAMSHAFT CONTROLLER ACTUATOR (V6 TURBO)