Install Camshaft Sensor (Intake Camshafts)
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Replace O-ring on camshaft sensor for intake camshafts.
- 1.2 Grease O-ring on hall sender for intake camshafts w ith a light coating of Kluber Syntheso Glep.
- 1.3
Tighten screw on camshaft sensor.
- Tightening torque 9 Nm (6.5 ftlb.) (6.6 ftlb.)