Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Screw securing torque support bracket to engine (top) | M8 x 45 | Tightening torque | 20 Nm (15 ftlb.) | ||
| Screws for coolant pipes | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Fastening screw for high-pressure fuel line | Replace | tightening torque | 8 Nm (5.9 ftlb.) | ||
| Fastening screw for high-pressure fuel line | final tightening torque | 45° | |||
| Fastening screw for fuel line support | M6 x 12 | Tightening torque | 9 Nm (6.6 ftlb.) | ||
| Union nut for fuel line | Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. | tightening torque of | 10 Nm (7.4 ftlb.) |