LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (24 Fuel System - Electronic Injection 3.0L -- 95B - MACAN (95B)) >> WM, 244219 Removing And Installing Throttle Housing (V6 MONOTURBO) >> Installing Throttle Housing

Installing Throttle Housing

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Replace throttle housing seal.
    2. 1.2  Tighten screws for throttle housing.
      • Tightening torque 7 Nm (5 ftlb.) 
    3. 1.3  Tighten screw-type clamp.
      • Tightening torque 5.5 Nm (4 ftlb.) 
scientia non olet · About LEMON Manuals