LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (38 Automatic Transmission Gears Control 2.0L -- 95B - MACAN (95B)) >> WM, 387719 - Removing And Installing Control Mechanism For Transmission >> Subsequent Work >> Replacing Control Unit For Transmission

Replacing Control Unit For Transmission

WARNING: This page is about a different variant/trim than selected.

After replacing control mechanism for transmission: 

  1. Program control mechanism for transmission.

    Automatic programming.

    1. 1.1  Program control mechanism for transmission using the PIWIS Tester. 
    2. 1.2  Overview -> PDK -> Programming -> Automatic programming -> F12.
    3. 1.3  Perform automatic programming
  2. Teach engine immobiliser.
    1. 2.1  Overview -> Diagnostics -> Online teaching functions > Engine immobiliser -> F12
  3. Calibrate control mechanism for transmission. 

    Calibrate control mechanism for transmission using the PIWIS Tester. 

    1. 3.1  Overview -> PDK -> Maintenance/repairs -> Calibration after replacing  mechatronics -> F12
    2. 3.2  Follow the instructions on the PIWIS Tester.  F12.
    3. 3.3  Start the calibration process by pressing F8.
    4. 3.4  Erase fault memory.
  4. Code control mechanism for transmission. 

    Code control mechanism for transmission using the PIWIS Tester. 

    1. 4.1  Overview -> PDK -> Coding/adaptations -> Automatic coding -> F12
    2. 4.2  Perform automatic coding.
scientia non olet · About LEMON Manuals