Subsequent Work: Notes

WARNING: This page is about a different variant/trim than selected.

Install ATF pan.
- WM, 375519 - REMOVING AND INSTALLING ATF PAN
Fill in ATF.
- WM, 370235 - CHECKING AND TOPPING UP ATF
Connect the battery.
- WM, 270619 REMOVING AND INSTALLING VEHICLE ELECTRICAL SYSTEM BATTERY
Calibration after removing and installing the control mechanism:
Calibrate control mechanism for transmission using the PIWIS Tester.
1. 4.1 Overview -> PDK -> Maintenance/repairs -> Calibration after removing and installing mechatronics -> F12
2. 4.2 Follow the instructions on the PIWIS Tester -> F12.
3. 4.3 Start the calibration process by pressing F8.
4. 4.4 Erase fault memory.