Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Install wire harness.
- WM, 381819 - REMOVING AND INSTALLING WIRE HARNESS
Install ATF pump.
- WM, 385619 - REMOVING AND INSTALLING ATF PUMP
Install double clutch.
- WM, 304919 REMOVING AND INSTALLING DOUBLE CLUTCH
Top up oil for final drive.
- WM, 399055 CHANGING OIL FOR ALL-WHEEL FINAL DRIVE (TRANSMISSION OIL) or WM, 399055 CHANGING OIL FOR FINAL DRIVE or WM, 399055 CHANGING OIL FOR FINAL DRIVE (TRANSFER BOX)
Information

The PIWIS Tester instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms. Different text or additional information may appear on the PIWIS Tester.
Calibrate sensor module using the PIWIS Tester.
1. 5.1 Connect the PIWIS Tester to the vehicle and start it. Switch on ignition.
2. 5.2 Select the required vehicle type.
3. 5.3 Select PDK (Porsche Doppelkupplung (PDK)) control unit and press >> to continue.
4. 5.4 Select the Maintenance/repairs menu and press >> to confirm your selection.
5. 5.5 Calibrate must be selected. Then press F12 to continue.
6. 5.6 Calibration after replacing sensor module (selector-lever position) must be selected. Then press F8 to start the process.
7. 5.7 The message "Calibration completed successfully" appears. Press F12 to end the process.
8. 5.8 Switch off the ignition.
9. 5.9 Wait 30 seconds.
10. 5.10 Switch on the ignition.