Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Steering gear to front-axle carrier | M12 x 1.5 x 153 thread/always use new screws or bolts and nuts following removal | Initial tightening | 80 Nm (59 ftlb.) | ||
| Steering gear to front-axle carrier | M12 x 1.5 x 153 thread/always use new screws or bolts and nuts following removal | Final tightening | + 180° | ||
| Tie-rod ball to wheel carrier cone | M12 x 1.5 thread/always use new nuts following removal | Tightening torque | 100 Nm (74 ftlb.) | ||
| Intermediate steering shaft to steering gear (universal joint) | M8 x 30 thread/always use new screws or bolts following removal | Initial tightening | 20 Nm (15 ftlb.) | ||
| Intermediate steering shaft to steering gear (universal joint) | M8 x 30 thread/always use new screws or bolts following removal | Final tightening | + 90° | ||
| Bearing clamp securing stabiliser to front axle carrier | Item 28: Collar nut M8/replace | Tightening torque | 30 Nm (22.1 ftlb.) |