Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Steering column to intermediate steering shaft (universal joint) | M8 x 30 thread/always use new screw or bolt following removal | Tightening torque | 30 Nm (22 ftlb.) | ||
| Intermediate steering shaft to steering gear (universal joint) | M8 x 30 thread/always use new screw or bolt following removal | Tightening torque | 30 Nm (22 ftlb.) |