Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Steering column to retaining frame/module cross member | M8 x 30 thread | Tightening torque | 20 Nm (14.8 ftlb.) | ||
| Steering column on mounting saddle | M8 x 22 thread | Tightening torque | 20 Nm (14.8 ftlb.) | ||
| Steering column to intermediate steering shaft (universal joint) | Thread, M8 x 30/always use new screw following removal | Initial tightening | 20 Nm (14.8 ftlb.) |