Allocation Of Connecting-Rod Bearing Shells And Measurements
WARNING: This page is about a different variant/trim than selected.
Information
- For more information, see Porsche Spare Parts Information.
Information
- Only polymer bearing shells may be fitted in the connecting rod cap (bottom).
- Only bronze alloy bearing shells may be fitted in the connecting rod (top).
Measurements for connecting rod bearings:
| Measurements for connecting rod bearings: | ||
|---|---|---|
| Play | New | Wear limit |
| Axial play | 0.10... 0.35 mm | 0.40 mm |
| Radial play | 0.02... 0.06 mm | 0.09 mm |
| Measure radial play using Plastigage | ||
| When measuring radial play, do not rotate the crankshaft | ||
Allocation of connecting-rod bearing shells:
| Connecting-rod bearing | Permitted colour combinations of bearing shells | ||
|---|---|---|---|
| Top/connecting rod Bronze alloy bearing shells | Yellow | Red | Blue |
| Bottom/connecting rod cap Polymer bearing shells | Yellow | Blue | Red |