LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (21 Exhaust Gas Turbocharging 2.0L -- 95B - MACAN (95B)) >> WM, 213919 Removing And Installing Moulded Hose (R4) >> Installing Moulded Hose >> Installing Moulded Hose (Turbocharger - Charge Air Cooler)

Installing Moulded Hose (Turbocharger - Charge Air Cooler)

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Tighten the screw clamp of the moulded hose on the turbocharger.
      • Tightening torque 5.5 Nm (4 ftlb.) 
    2. 1.2  Tighten screw-type clamp on moulded hose for charge air cooler right.
      • Tightening torque 5.5 Nm (4 ftlb.) 
scientia non olet · About LEMON Manuals