LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (19 Engine - Cooling 2.0L -- 95B - MACAN (95B)) >> WM, 193519 - Removing And Installing Cooling-Air Flaps >> Subsequent Work

Subsequent Work

WARNING: This page is about a different variant/trim than selected.
  1. Install front air guide (at the top).

    > 192419 - REMOVING AND INSTALLING FRONT AIR GUIDE 

  2. V6 Turbo only: 

    Install pressure pipe (from charge-air cooler to charge-air cooler) at the top.

    > 214119 - REMOVING AND INSTALLING PRESSURE PIPE

  3. Only for vehicles with distance measuring sensor: 

    Installing control unit for distance measuring sensor.

    > 278519 - REMOVING AND INSTALLING CONTROL UNIT FOR DISTANCE MEASURING SENSOR

  4. Perform cooling-air flap adaptation:
    1. 4.1  Perform cooling-air flap adaptation using the PIWIS Tester. 
      1. 4.1.1  Connect the PIWIS Tester  to the vehicle, start the PIWIS Tester  and switch on ignition.
      2. 4.1.2  Select the DME control unit  in the control unit overview. 
      3. 4.1.3  In the Maintenance/repair  s tab, select Adaptations  and then sub-procedure: Select cooling-air flaps. 
      4. 4.1.4  Follow the instructions on the PIWIS Tester. 
scientia non olet · About LEMON Manuals