Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Install ATF cooling line (rear section).
> 386219 - REMOVING AND INSTALLING LINE FOR ATF COOLING (R4)
Install power-steering gear.
> 489019 - REMOVING AND INSTALLING POWER-STEERING GEAR
Install front anti-roll bar.
> 407719 - REMOVING AND INSTALLING FRONT ANTI-ROLL BAR
Fill in engine oil.
> 170117 - DRAINING AND FILLING ENGINE OIL (R4)
Secure engine mount.
1. 5.1 Replace screws.
2. 5.2 Tightening torque: Initial tightening 90 Nm Final tightening 90°
Remove engine safety device.
Remove wheels from front axle.
> 440519 - REMOVING AND INSTALLING WHEEL