Installing Oil-Pressure Sender

1. Installation is performed in reverse order. Pay particular attention to the following:
   1. 1.1  Replace sealing ring on oil-pressure sender.
   2. 1.2  Tighten oil-pressure sender.

Oil-pressure sender to oil filter bracket: 

Tightening torque 20 Nm (15 ftlb.) 

Oil-pressure sender for reduced oil pressure: 

Tightening torque 20 Nm (15 ftlb.) 

Oil-pressure sender to crankcase: 

Tightening torque 20 Nm (15 ftlb.)