Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Screw securing centre transmission housing to front transmission housing | Continue to tighten in diagonally opposite sequence | Final tightening | + 120° | ||
| Screw securing side shaft to all-wheel output shaft | M14 x 1.5/re place | Initial tightening | 100 Nm (74 ftlb.) | ||
| Screw securing side shaft to all-wheel output shaft | Final tightening | + 120° | |||
| Screw securing centre transmission housing to front transmission housing | Tighten in diagonally opposite sequence/replace | Initial tightening | 8 Nm (6 ftlb.) | ||
| Screw securing transmission housing cover to centre transmission housing | M8 x 43/replace | Initial tightening torque | 20 Nm (15 ftlb.) | ||
| Screw securing transmission housing cover to centre transmission housing | M8 x 55/replace | Initial tightening torque | 15 Nm (11 ftlb.) | ||
| Screw securing transmission housing cover to centre transmission housing | Final tightening | + 90° | |||
| Screw securing lid to final drive | Final tightening | + 90° |