Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Secure both front drive shafts at the transmission side.
- Install rear cardan shaft.
- Install power-steering gear.
- Install front-axle support.
- Connect both sections of the line for ATF cooling.
> 386219 - REMOVING AND INSTALLING LINE FOR ATF COOLING (V6 TURBO)
- Depending on model: Install particle filter/catalytic converter.
Vehicles with particle filter:
> 267419 - REMOVING AND INSTALLING THE PARTICLE FILTER (V6 MONOTURBO/TWO-PIECE HOLDER)
Vehicles without particle filter:
- Secure torque support to the engine.
> 103719 - REMOVING AND INSTALLING TORQUE SUPPORT (V6 TURBO)
- Connect the battery.
> 270619 - REMOVING AND INSTALLING VEHICLE ELECTRICAL SYSTEM BATTERY