Installing Engine Carrier
WARNING: This page is about a different variant/trim than selected.
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
- → Secure components to prevent them from falling down.
Information
- This work can only be performed when the engine has been suspended on the body.
Information
The procedure for removing and installing is described for one side as an example. The procedure for the other side is almost identical.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Screw in and tighten screws.
- Tightening torque 50 Nm (37 ftlb.)