Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Screws on crankcase cover | Replace following removal. | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screws on crankcase cover, on belt side | Replace following removal. | Final tightening | + 90° | ||
| Screws on crankcase cover in oil guide housing | Replace following removal. | Final tightening | 9 Nm | ||
| Screw on guide tube for oil dipstick | Replace O-ring. | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Screws for air-conditioning compressor bracket - | replace | Initial tightening | 8 Nm (6 ftlb.) | ||
| Screws for change-over valve holder | Tightening torque | 9 Nm (6.5 ftlb.) |