Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/relace, tighten in diagonally opposite sequence | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten in diagonally opposite sequence | Final tightening | + 90° | ||
| Connecting rod bolts | Oil thread and contact surfaces/replace | Initial tightening | 50 Nm (37 ftlb.) | ||
| Connecting rod bolts | Oil thread and contact surfaces/replace | Final tightening | + 90° | ||
| Banjo bolt for oil spray jet | Initial tightening | 10 Nm (7.5 ftlb.) | |||
| Banjo bolt for oil spray jet | Final tightening | + 45° |