LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (10 Engine - Crankcase, Suspension 3.0L -- 95B - MACAN (95B)) >> WM, 100119 Removing And Installing Engine (V6 Turbo) >> Subsequent Work >> Subsequent Work For Diagnostic Scopes

Subsequent Work For Diagnostic Scopes

WARNING: This page is about a different variant/trim than selected.
  1. Connect tester to the vehicle and start it.
  2. Switch on ignition.
  3. Start diagnostics.
  4. Select engine electronics (DME) control unit.
  5. Select Maintenance/Repairs  tab:
    1. 5.1  Only for hybrid vehicles: Decoupler commissioning without part replacement 
    2. 5.2  Only for V6T and V8T: Working on the high-temperature coolant circuit: Draining and filling coolant 
    3. 5.3  Only for V6T and V8T: Working on the high  -temperature coolant circuit: Bleed cooling system 
    4. 5.4  Only for V6T and V8T: Checking oil level 
    5. 5.5  Only for reconditioned engine: Performing throttle valve  adaptation.
    6. 5.6  Only for reconditioned engine: Reset sensor wheel adaptation 
      • 287319 Removing and installing pulse sender 
  6. Select the Drive links/checks  tab and reset under Learning values 
    1. 6.1  Only for replacing injector valves and reconditioned engine: Reset injector valve learning values 
    2. 6.2  Only for R4: Resetting chain elongation 
    3. 6.3  Only for R4: Replacing turbocharger and reconditioned engine: Reset, turbocharger learning values 
  7. Read out all fault memories,  process and delete existing faults if necessary.
  8. Exit the diagnostic application. End operational readiness on the vehicle. Disconnect tester from the vehicle.
scientia non olet · About LEMON Manuals