Installing Battery-Starter Wire Harness (From External Power Connection To Starter)

1. Installation is performed in reverse order. Pay particular attention to the following:
2. Tighten fastening nut -3-  securing B+ positive cable to the potential distributor on the longitudinal member to > Tightening - torque 20 Nm (15 ftlb.)  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Potential distributor

3. Tighten fastening nut -2-  securing ground line to the longitudinal member to > Tightening - torque 20 Nm (15 ftlb.)  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Electric plug connection

4. Tighten fastening nut -5-  securing positive cable at the jump-start point to > Tightening - torque 7.5 Nm (5.5 ftlb.)  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Jump-start point

5. Tighten connection terminal -4-  securing B+ positive cables to the jump-start point to > Tightening - torque 20 Nm (15 ftlb.)  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Jump-start point

6. Tighten fastening nut -1-  securing positive cable to B+ positive cable to > Tightening - torque 7.5 Nm (5.5 ftlb.)  .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Jump-start point