Technical Values
TIGHTENING TORQUE SPECIFICATION
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Flywheel to crankshaft | Internal serration, M10 x 1 x 29, microself-locking - replace screws | Initial tightening | 25 N.m (19 ft lb.) | ||
| Flywheel to crankshaft | Internal serration, M10 x 1 x 29, microself - locking - replace screws | Final tightening torque angle | + 120° |