Removing Oil Separator
- Unscrew screw -4-
on the oil separator -3-
.
Front oil separator (shown on the 981)
- Release and pull off positive crankcase ventilation line -3-
at the oil separator.
Crankcase vent line (shown on the 981)
- Unscrew screw -1-
.
Oil separator screw under intake-air distributor (shown on the 981)
- Carefully press positive crankcase ventilation line aside and out of the work area.
- Pull oil separator -1-
up off the oil bracket -arrow A-
and remove it -arrow a-
.
Removing oil separator (shown on the 981)
- Clean connection points and seal with stoppers.