Subsequent Work

Information 

The instructions in the PIWIS Tester  take precedence and in the event of a discrepancy, these are the instructions that must be followed. A discrepancy may arise with later software versions.

1. If a new actuator was installed:  Confirm actuator in PIWIS Tester. 
   1. 1.1 Select Parking brake in the control unit overview.
   2. 1.2 Select Drive links/checks.
   3. 1.3 Select Confirm actuator replacement.
2. Install parking-brake shoes.

   > 468320 REMOVE AND INSTALL BRAKE SHOES .

3. Adjusting parking-brake shoes.

   > WM, 468316 ADJUSTING AND CALIBRATING PARKING-BRAKE SHOES