LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> 718 Spyder >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> 61 Convertible Top, Hardtop -- 718 SPYDER >> WM, 6128IN Cleaning And Care Instructions For Convertible Top >> Cleaning And Care Instructions For Convertible Top >> Preparing Convertible Top For Hot-Steam Cleaning

Preparing Convertible Top For Hot-Steam Cleaning

NOTE: Hot steam on seals 
  • Risk of damage to components 

    → Do not use hot steam on seals.

    → Use demineralised/distilled water to prevent the formation of stains/spots.

    → Be careful when using hot steam.

G16223579Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Typical creases on the convertible top

Technical Data: Hot-steam cleaner

Information 

Hot-steam cleaning can reduce or remove shiny spots and creases.

  1. Hot-steam cleaning.
    1. 1.1 Recommendation:  Use the ceramic cleaner attachment.

      When using the ceramic cleaner attachment: Place the attachment on the convertible top covering without pressure and move it over the convertible top covering in slow, even strokes as you would when ironing fabric.

      G16223580Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Using ceramic cleaner attachment

    2. 1.2 Alternatively:  Use the nozzle attachment.

      When using the nozzle attachment: Maintain a distance of approx. 50 mm to 100 mm from the convertible top. Move the attachment over the convertible top covering in slow, even strokes as you would when ironing fabric.

      G16223581Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Using nozzle attachment

  2. Close the convertible top and leave it to dry following hot-steam cleaning.

    Information 

    Let the convertible top dry completely before use.

  3. Impregnate the convertible top with convertible top care product from the Tequipment care case, Cabriolet  .

    Spray convertible top care product evenly and lightly from a distance of approx. 10 to 20 cm. Do not spray on glass, polyglass or painted surfaces and protect these surfaces from spray mist. Apply 2 or 3 times to seams if necessary. Only spray for a few seconds. Leave to dry off well following application. Do not apply in strong sunlight or on heated surfaces.