LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> 718 Spyder >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 63 Bumper -- 718 SPYDER >> WM, 635519 Removing And Installing Rear Bumper >> Installing Rear Bumper

Installing Rear Bumper

  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1 Set in screws on the top and tighten to > Tightening torque 3.2 N.m (2.4 ft lb.)  .
    2. 1.2 Insert wheel housing screws and tighten to > Tightening torque 3.2 N.m (2.4 ft lb.)  .
    3. 1.3 Insert bottom centre screws and tighten to > Tightening torque 4.5 N.m (3.3 ft lb.)  .
    4. 1.4 Insert screws below and tighten to > Tightening torque 3.2 N.m (2.4 ft lb.)  .
scientia non olet · About LEMON Manuals