Removing Inner Side Section

Information 

Loosen connection points on one side only. Do not damage the sheet-metal panel underneath.

Fig 1: Inner Side Section Component Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position of inner side section

1. Drill out spotwelds. > Nr.129 - Spotweld drill  > VAS 882 001 - Spot-weld remover 
   1. 1.1  Remove rear filler plate.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing rear filler plate

2. Drill out spotwelds. > Nr.129 - Spotweld drill  > VAS 882 001 - Spot-weld remover 
   1. 2.1  Grind down welded seam in area -C-  .
   2. 2.2  Grind down welded seam in area -arrows-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing inner side section

3. Drill out spotwelds -A-  from the inside. > Nr.129 - Spotweld drill  > VAS 882 001 - Spot-weld remover 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing inner side section

4. Heat bonding areas.
   1. 4.1  Remove inner side section.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing inner side section