Installing rear trunk floor panel

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Apply adhesive to the areas shown. > Application depth 3.0 mm 

   Working with body structural adhesive

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Applying adhesive

2. Fit and secure rear trunk floor panel. Check gap dimensions.

   > 5X00IN DIAGRAM - BODY GAP DIMENSIONS

   1. 2.1  Rivet in the rear trunk floor panel in the marked area -A-  . > BLIND RIVET 999.190.228.01 
   2. 2.2  Screw on the rear trunk floor panel in the marked area -B-  . > LENS-HEAD SCREW 999.073.917.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Riveting and screwing on rear trunk floor panel