LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> 718 Spyder >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 53 - Body Rear - 718 SPYDER >> WM, 530555 Replacing Rear Closing Panel >> Preparing Rear Closing Panel For Installation

Preparing Rear Closing Panel For Installation

  1. Fit closing panel and secure it to the body.
    1. 1.1  Drill bores for the rivets through the existing holes. > Diameter 6.6 mm 
  2. Remove closing panel.
  3. Countersink bores for installing countersunk rivets. > Nr.202 - Countersink-area A. 
    G14394900Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Preparing rear closing panel for installation

  4. Prepare connection areas for bonding.
scientia non olet · About LEMON Manuals